The pipe equipment production line is an assembly line for pipe production. The following editor will introduce how to deal with the failure of the pipe equipment production line:

1. The outer coating of the pipe equipment production line is not firmly bonded, and the outer glue is not wrapped well

Solution: a. Make sure that there is glue on the surface of the pipe, and the vacuum of glue suction should be good; b. Increase the temperature of the aluminum strip and turn on the flat heating gun;

2. The surface of the aluminum tube of the pipe equipment production line has ridges (protrusions)

(1) The pipe equipment production line is not firmly bonded. See which forming wheel the protrusion occurs on, and then see the aluminum tube coating after which forming wheel. Open the aluminum and the tube blank to see the bonding after the forming wheel. If there is extruded molten material between the tube blank and the aluminum strip, it means that the temperature is too high. Appropriately reduce the temperature of the air gun heating here. If you find that there is a molten material extruded between the tube blank and the aluminum strip, it means that the temperature is too high. Appropriately reduce the temperature of the air gun heating here. If the bonding is not good, the temperature or pressure here should be increased, the screw of the pressing wheel should be adjusted, and the gap between the wheel and the aluminum tube should be observed from the side; the quality of the aluminum strip glue is problematic, such as film creases, bubbles between the glue and the aluminum foil, the film is lumpy, partly without glue, and the local peeling strength is insufficient.

(2) The position of the forming wheel is incorrect

3. The surface of the aluminum tube of the pipe equipment production line is scratched:

(1) There are dark scratches on the outer surface, and there are impurities in the outer die. The die should be cleaned; because the aluminum strip and the inner tube are not firmly bonded, the glue remains on the outer die, and the outer die should be cleaned; adjust the outer extrusion amount.

(2) There are foreign burrs on the water tank support wheel with obvious scratches; there are foreign impurities in the silicone skin or cooling water cloth of the sealing water tank.